DELTA UNISAW MITER-GAUGE HOLDER

DELTA UNISAW UNDER-TABLE MITER-GAUGE HOLDER

Always know where your miter gauge is.

This holder mounts beneath the table of a compatible vintage Delta Unisaw, keeping your miter gauge conveniently within reach while safely out of the way.

NO DRILLING REQUIRED:

The holder installs using two existing threaded table-mounting holes. No holes need to be drilled in the Unisaw cabinet or table.

The heavy-wall PVC tube provides a generous opening that makes the miter gauge easy to insert and remove. The gauge is stored with its steel bar resting against PVC rather than metal, helping prevent rattling while the saw is running.

FEATURES:

• Convenient under-table storage
• No drilling or permanent modification required
• Uses existing threaded mounting holes
• Heavy-wall gray PVC storage tube
• Adjustable bracket spacing
• Can be installed on the left or right side of the saw
• Does not extend beyond the fence-guide rails
• Does not interfere with normal saw operation
• Compatible with an original Delta miter gauge or our long-bar billet-aluminum miter gauge
• Allows our Unisaw wrench hanger to remain installed on the right-front table bolt

INCLUDED:

• One heavy-wall gray PVC storage tube
• Two heavy-duty tube clamps
• Two laser-cut and machined 6061 aluminum mounting brackets
• Two flat washers
• Two longer mounting bolts

The holder arrives preassembled for straightforward installation.

IMPORTANT:

This listing is for one miter-gauge holder and its mounting hardware. The Unisaw, miter gauges, wrench, wrench hanger, fence rails, and all other components shown are not included.

One holder stores one miter gauge. Install one on each side of the saw if you want convenient storage for two gauges.

This holder was designed for compatible Delta Unisaw's. It may fit other table saws with accessible table-mounting bolts, but compatibility with other machines is not guaranteed. Please compare the available mounting locations and clearances on your saw before ordering.