DELTA UNISAW MITER HOLDER

MITER HOLDER - HOLSTER - SCABBARD....................CALL IT WHAT YOU WANT......... BUT NOW WITH THIS DEVICE, YOU WILL ALWAYS KNOW WHERE YOUR MITER IS. 

This neat little item attaches to the underside of your Unisaw table and stores your miter conveniently, safely, and close at hand, but totally out of the way. 

THE GOOD THING.........THERE ARE NO HOLES TO DRILL IN YOUR VINTAGE UNISAW CABINET.

Your miter usually lays on the saw's tabletop so it is there when you need it.........but when you don't need it, you cart it off to the bench................ or anywhere else you can find a place to lay it down.

Why not store it at the saw?  This miter holder keeps your miter out of the way, close at hand, convenient, and safe from falling off the bench.

The miter is easy to grip with the handle side down, easy to insert in the generous tube opening, doesn't rattle when the saw is running, and is stored with the miter's metal rail in contact with PVC... not metal to metal.

This PVC tube, with its two brackets, bolts to the underside of the Unisaw's table using two of the existing table top's threaded bolt holes. 

This holder accommodates a stock miter or even our long bar billet aluminum miter (Both are shown in one of the photos and the difference is dramatic !!!).  Plus, the location of this holder still allows our wrench hanger and wrench to stay conveniently in the designed position on the same right front table top bolt.

This holder can be installed on either the left or right side of the saw.......or if you have a couple of miters and want to store both conveniently close by..... buy two.

The position of the miter does not interfere with any of the saw's functions.  The head of the miter does not protrude out past the fence guide rails, so it is not at all in the way when operating the saw.

The easy-to-install miter holder comes preassembled with a gray heavy wall PVC tube, a pair of heavy duty clamps, and a pair of drilled and tapped 6061 aluminum brackets.

Flat washers and longer bolts are included to replace the stock bolts when installing the holder to the underside of the table.

With your miter conveniently stored in this holder under the saw's table, it is safe and secure.  It can't fall from the bench or from the pile of boxes you laid it on.  It can't be damaged and the angular setting or the squareness of the miter won't be altered by a tumble onto the floor.  Why would you not have one of these on your saw?